Limiting Reagent

Mix reactant molecules and see which one runs out, how much product forms and what is left over

Intermediate

Mode

2H2+O22H2O
ReactantsProductsHHHHHHHHHHHHHHHHHHHHOOOOOOOHHOHHOHHOHHOHHOHH

H2In excess

10 ÷ 2 = 5.00 reaction sets

Used 0, left 10

O2Limiting

3 ÷ 1 = 3.00 reaction sets

Used 0, left 3

Products

H2O: 0 of 6 possible

Reactions run: 0 of 3

Which reactant runs out first?

Think of making sandwiches with 2 slices of bread and 1 slice of cheese each. With 10 slices of bread and 3 slices of cheese you can make only 3 sandwiches: the cheese runs out first, and 4 slices of bread are left over. The cheese is the limiting reagent and the bread is in excess, even though you started with more bread.

Chemical reactions work the same way. The balanced equation is the recipe: 2H₂ + O₂ → 2H₂O needs two hydrogen molecules for every oxygen molecule. Divide the amount of each reactant by its coefficient to see how many times the recipe could run on that reactant alone. The smallest number is how many times it actually runs.

Counting molecules only works in the particle picture. In the lab you weigh reactants, so you first convert grams to moles with each molar mass. This is why a lighter reactant can still be in excess: 10 g of hydrogen is almost 5 mol, while 64 g of oxygen is only 2 mol.

Limiting reagent

The reactant that is used up first. Once it is gone the reaction stops, so it alone decides how much product can form.

Excess reagent

Every other reactant. Some of it is left over at the end, unreacted, because there was nothing left for it to react with.

Divide by the coefficient

Comparing raw moles is not enough. Divide each reactant’s moles by its coefficient to get how many “reaction sets” it can supply; the smallest wins.

Theoretical vs actual yield

The theoretical yield is the most product the limiting reagent allows. Real experiments recover less, and percent yield measures how close they got.

Key formulas

Find the limiting reagent

ξ = min(nᵢ / aᵢ); the reactant giving the minimum is limiting

nᵢ
moles of reactant i available (n = m / M)
aᵢ
coefficient of reactant i in the balanced equation
ξ
extent of reaction: how many times the equation runs, in mol

Theoretical yield and excess left over

nproduct = bⱼ · ξ,   mproduct = bⱼ · ξ · Mⱼ,   nleft = nᵢ − aᵢ · ξ

bⱼ, Mⱼ
coefficient and molar mass of product j

Percent yield

percent yield = actual yield / theoretical yield × 100%

Reactions in the visualizer

Balanced equationMolar masses (g/mol)Mole ratio
2H₂ + O₂ → 2H₂OH₂ 2.016, O₂ 31.998, H₂O 18.0152 : 1 : 2
N₂ + 3H₂ → 2NH₃N₂ 28.014, H₂ 2.016, NH₃ 17.0311 : 3 : 2
CH₄ + 2O₂ → CO₂ + 2H₂OCH₄ 16.043, O₂ 31.998, CO₂ 44.009, H₂O 18.0151 : 2 : 1 : 2
2Al + 3Cl₂ → 2AlCl₃Al 26.982, Cl₂ 70.900, AlCl₃ 133.3322 : 3 : 2
2Na + Cl₂ → 2NaClNa 22.990, Cl₂ 70.900, NaCl 58.4402 : 1 : 2

How to use this visualizer

  1. 1
    Choose a reaction. The balanced equation is shown above the controls.
  2. 2
    In Particle picture mode, set how many molecules of each reactant you start with, then press React. Each reaction set is outlined in amber before it combines into products on the right.
  3. 3
    Use One reaction to go a single step at a time. When nothing more can react, the leftover molecules are outlined in blue and the limiting reactant card turns amber.
  4. 4
    Switch to Grams and moles to enter real amounts in grams or moles. The table divides each reactant’s moles by its coefficient and highlights the smallest.
  5. 5
    Read the step-by-step calculation, then type an actual yield to get the percent yield for any product.

Common mistake: the smaller amount is not always limiting

The limiting reagent is not simply the reactant with the smaller mass, or even the smaller number of moles. In N₂ + 3H₂ → 2NH₃, 1.0 mol of N₂ and 2.4 mol of H₂ makes H₂ limiting, because 2.4 ÷ 3 = 0.8 is smaller than 1.0 ÷ 1 = 1.0. Always divide by the coefficients.

Practice problems

Problem 1: Making ammonia

14.0 g of N₂ reacts with 4.00 g of H₂: N₂ + 3H₂ → 2NH₃. Which reactant is limiting, what mass of NH₃ can form, and how much of the excess reactant is left? (N₂ 28.014, H₂ 2.016, NH₃ 17.031 g/mol)
Show solution

N₂: 14.0 ÷ 28.014 = 0.4998 mol; ÷ 1 = 0.4998

H₂: 4.00 ÷ 2.016 = 1.984 mol; ÷ 3 = 0.6614

0.4998 < 0.6614, so N₂ is limiting and ξ = 0.4998 mol

NH₃: 2 × 0.4998 = 0.9995 mol × 17.031 g/mol = 17.02 g

H₂ used: 3 × 0.4998 = 1.499 mol × 2.016 = 3.022 g; left: 4.00 − 3.022 = 0.978 g

N₂ is limiting; 17.0 g NH₃ forms; 0.978 g H₂ is left over

Problem 2: Percent yield

5.40 g of aluminium reacts with 15.0 g of chlorine gas: 2Al + 3Cl₂ → 2AlCl₃. The student collects 15.2 g of AlCl₃. What is the percent yield? (Al 26.982, Cl₂ 70.90, AlCl₃ 133.332 g/mol)
Show solution

Al: 5.40 ÷ 26.982 = 0.2001 mol; ÷ 2 = 0.1001

Cl₂: 15.0 ÷ 70.90 = 0.2116 mol; ÷ 3 = 0.07052

Cl₂ is limiting, ξ = 0.07052 mol

Theoretical AlCl₃: 2 × 0.07052 = 0.1410 mol × 133.332 g/mol = 18.81 g

Percent yield = 15.2 ÷ 18.81 × 100% = 80.8%

Percent yield ≈ 80.8% (Cl₂ limiting, 1.59 g Al left over)

Related visualizations

Discussion

Questions, ideas or a different approach? Join the conversation.